Miller ST-24w, Owner'S Manual

Page: 12 / 32

OM-287388 Page 8
SECTION 3 − SPECIFICATIONS
3-1. Serial Number And Rating Label Location
The serial number and rating information for this product is located on back of control box. Use rating label to determine input power requirements
and/or rated output. For future reference, write serial number in space provided on back cover of this manual.
3-2. Unit Specifications
Type of Input
Power
Welding
Power
Source Type
Wire Feed
Speed Range
Wire
Diameter Range
Welding Circuit
Rating
Overall
Dimensions
Weight
24 Volts AC Single
Phase
4 amps
50/60 Hz
Constant Voltage
(CV) DC With
14-Pin And
Contactor
Control
1.3 To 20.0 MPM
(51 to 788 IPM)
0.6 To 1.8 mm
(.023 To .068/.072 in.)
Max Spool Weight:
27 kg (60 lb)
100 Volts,
500 Amperes, 60%
Duty Cycle
Length: 597 mm
(23-1/2 in.)
Width: 273 mm
(10-3/4 in.)
Height: 279 mm
(11 in.)
17.0 kg
(37-1/2 lb)
3-3. Environmental Specifications
A. IP Rating
IP Rating
IP23S
This equipment is designed for outdoor use. It may be stored, but is not intended to be used for welding outside during precipitation unless
sheltered.
IP23S 2014 − 06
B. Information On Electromagnetic Fields (EMF)
!
This equipment shall not be used by the general public as the EMF limits for the general public might be exceeded during welding.
This equipment is built in accordance with EN 60974 − 1 and is intended to be used only in an occupational environment (where the general public
access is prohibited or regulated in such a way as to be similar to occupational use) by an expert or an instructed person.
Wire feeders and ancillary equipment (such as torches, liquid cooling systems and arc striking and stabilizing devices) as part of the welding
circuit may not be a major contributor to the EMF. See the Owner’s Manuals for all components of the welding circuit for additional EMF exposure
information.
S
The EMF assessment on this equipment was conducted at 0.5 meter.
S
At a distance of 1 meter the EMF exposure values were less than 20% of the permissible values.
ce-emf 1 2010-10
C. Information On Electromagnetic Compatibility (EMC)
!
This Class A equipment is not intended for use in residential locations where the electrical power is provided by the public low −
voltage supply system. There can be potential difficulties in ensuring electromagnetic compatibility in those locations, due to con-
ducted as well as radiated disturbances.
ce-emc 3 2011-09