Miller ST-24w, Owner'S Manual

Page: 21 / 32

OM-287388 Page 17
5-2. Optional Side Panel Controls
805 229-A
1 Wire Jog Control
Use Jog position to momentarily
feed welding wire at speed set on
Wire Speed control without ener-
gizing welding circuit or shielding
gas valve.
2
Wire Run-In Control
Use control to set wire feed speed
before arc is initiated.
3
Wire Burn-Back Control
Use control to prevent wire elec-
trode from sticking in weld pool.
Close side door.
1 2 3
SECTION 6 − MAINTENANCE & TROUBLESHOOTING
!
Disconnect power before maintaining.
6-1. Routine Maintenance
n
= Check
~
= Clean
l
= Replace
Every
3
Months
l Unreadable Labels ~ Weld Terminals nl Weld Cable l Cracked Parts
n 14-Pin Cord n Gas Hose and Fittings n Gun Cable
Every
6
Months
Or
~ Inside Unit ~ Drive Rolls