Miller Electric MOG-200C, Owner'S Manual

Page: 8 / 24

OM-805 Page 2
S-0835
1 Common Work Connection
2 Welding Power Source
3 Line Disconnect Device
4 Distribution Panel
5 Grid
This view illustrates how system
components are related.
1
2
3
4
4
5
( )
+ ( )
DCEP
DCEN
5
5
5
Figure 3-1. Typical Component Relationships
3-2. Selecting A Location And Moving Resistance Grid Or Multi-Grid Rack
WARNING
ELECTRIC SHOCK can kill.
•
Do not touch live electrical parts.
•
Turn Off welding power source, and disconnect
input power BEFORE moving grid.
FIRE OR EXPLOSION can result from
p l a c i n g u n i t o n , o v e r, o r n e a r
combustible surfaces.
•
Do not locate unit on, over, or near combustible
surfaces.
•
Do not install unit near flammables.
B L O C K E D A I R F L O W c a u s e s
overheating and possible damage to
unit.
•
Do not block or filter airflow.
Warranty is void if any type of filter is used.
FUMES can be hazardous; LACK OF
F R E S H A I R A N D P R O P E R
VENTILATION can be harmful.
•
Do not breathe welding fumes.
•
Place unit only where there is a good fresh air supply
and proper ventilation.
FA L L I N G E Q U I P M E N T c a n c a u se
serious personal injury and equipment
damage.
•
On racks, use lifting eyes to lift and move unit.
•
Use equipment of adequate capacity to lift the unit.
•
Use proper lifting procedures for racks to prevent
tipping and falling.
•
Have two persons of adequate physical strength lift
individual grids at handles.
swarn11.1* 3/93
ST-080 151-B / ST-800 261
Locate grid(s) near welding power
source.
Location should allow operation of
controls.
1 Handles
Use handles to lift unit.
2 Cart
Use cart to move unit.
1
18 in
(460 mm)
18 in
(460 mm)
18 in
(460 mm)
Location Movement
2
Figure 3-2. Location and Movement Of Resistance Grid