Miller Electric MOG-200C, Owner'S Manual

Page: 10 / 24

OM-805 Page 4
B. Camlok Connectors
sb6.6* 12/92 – ST-159 028
1 Weld Input Cable
Strip insulation as shown.
2 Copper Strip (Two Included)
3 Connector Body
Wrap strip around bare weld cable
(use two on small diameter cable),
and insert into connector body.
4 Setscrew
Tighten setscrew against copper
strip.
5 Handle
6 Pin
Slide handle over connector body
so holes align; secure by tapping
pin into place.
Tools Needed:
7/32 in
1
1 in
2
4
(26 mm)
3
5 6
Figure 3-4. Female Camlok Connector Assembly
sb6.4* 11/92 – ST-155 015
1 Weld Output Cable
Strip insulation as shown.
2 Copper Strip (Two Included)
3 Connector Body
Wrap strip around bare weld cable
(use two on small diameter cable),
and insert into connector body.
4 Setscrew
Tighten setscrew against copper
strip.
5 Handle
6 Pin
Slide handle over connector body
so holes align; secure by tapping
pin into place.
1
1 in
2
4
(26 mm)
Tools Needed:
3
5 6
7/32 in
Figure 3-5. Male Camlok Connector Assembly