Miller Electric 600 X, Owner'S Manual

Page: 25 / 108

OM-4428 Page 21
SECTION 5 − INSTALLATION
install3 2007 − 04 − Ref. 800 652 / Ref. 800 477-A / 803 274 / 804 712
!
Always securely fasten weld-
ing generator onto transport
vehicle or trailer and comply
with all DOT and other applica-
ble codes.
!
Always ground generator
frame to vehicle frame to pre-
vent electric shock and static
electricity hazards.
!
If unit does not have GFCI re-
ceptacles, use GFCI-protected
extension cord.
NOTICE − Do not install unit where
air flow is restricted or engine may
overheat.
See Section 4-2 for lifting eye rat-
ing.
See Section 5-3 for mounting in-
formation.
Grounding:
1 Equipment Grounding Terminal
(On Front Panel)
2 Grounding Cable (Not Supplied)
3 Metal Vehicle Frame
Connect cable from equipment
ground terminal to metal vehicle
frame. Use #10 AWG or larger insu-
lated copper wire.
Electrically bond generator
frame to vehicle frame by met-
al-to-metal contact.
!
Bed liners, shipping skids,
and some running gears insu-
late the welding generator
from the vehicle frame. Al-
ways connect a ground wire
from the generator equipment
grounding terminal to bare
metal on the vehicle frame as
shown.
GND/PE
1
2
3
18 in
(460 mm)
18 in
(460 mm)
18 in
(460 mm)
18 in
(460 mm)
18 in
(460 mm)
Movement
5-1. Installing Welding Generator
OR OR
Grounding
OR
Location/Airflow Clearance
OR