Mikrotron eosens TS3, User Manual, Page: 61 / 120

page 52
7-2 Connect the Camera to a Network
TS3 setup may be done via the built-in camera GUI, Fas
M
otion so ftw are or the built-in Web-App.
This section add r esses the use of Fas
M
otion. F or details on the Web-App see”6 Using the Web App” on page
42.
The defualt network configu
r ation f or the TS3 is DHCP. If a DHCP host is not found on the
network, the TS3 will automati c ally configu r e itself with a 169.254.xxx.xxx IP address according to
Gig-E protocol.
To attach the TS3 to a network:
1. Before connecting t o power, connect the
TS3 to your network via a switch or router,
or directly to your PC using CAT 5E or CAT 6
Ethernet cable.
2. Power up the TS3. See “2-3 Powering Up,
Charging, and Power Down” on page 8.
3. Watch the LEDs on the camera’s RG-45
connector. When the camera connects to the
PC or local network the green LED will begin
to blink in a pa tt ern depending on connection
speed. (See “Table 3-2: Network LEDs” on
page 16.)
4. Start the Fas
M
otion so ftw are application
5. Click on the “Find Camera” icon, circled in red
on the figu r e shown here, to open the Find
Cameras dialog.
6. Click on the Local Area Connection d r op
down to get a list of available network
interfaces. Select the one you wish to use.
Note: It is possible to use a wireless adapter on
your PC, but it is not recommended because of
performance issues.
7. Click on the Scan bu tt on. Fas
M
otion will li s t
the cameras found available on the selected
interface.
8. Select the camera you wish to connect to
from the list and click on Connect. Cameras
are listed by MAC address. The camera serial
number is the last two digits of the MAC
address.
9. Make sure the “Stream Video Upon
Connection” b o x is checked if you wish to
view live video when the camera connects.
Note: If the camera you are looking for does
not appear on the list, you can click on the
Find Manually bu tt on and enter its IP address.
LEDs on RJ-45 Connector Camera
Networking LED
Green (Connection Amber (activity Amber (activity
1 Blink = 10Mb Blinks for all
network activit
Blinks for camera
network activity onl
2 Blinks = 100Mb
3 Blinks =1Gb
Table 7-1: TS3 Network LEDs
Figure 7-6: FasMotion “Find Camera” Icon
Figure 7-7: FasMotion “Find Cameras” Dialog