11S-3000M
page 47
6-6 Display Settings Tab
“Figure 6-10: Display Settings
T
ab”, is shown with the /Bit
Depth
and White Balance selection b
o
xes open.
Settings in this
T
ab control displayed images, both Live and
in Review, and all saved images except the RAW formats.
The Display
Bit Depth
selection b
o
x will only be present when
the camera has been placed in 10-bit mode in the Record
Settings
T
ab. (See “Figure 6-8: Record Settings
T
ab--
Advanced Setting
s
.) For more detail on bit selection see
“4-4
Setting Bi
t
Depth” on page 25.
Select
White Balance*
preset according to the available light.
The sliders used for
Brightness, Contrast, and Gamma
you
control over the same range as with the presets in the
camera, but it is a much finer
c
ontrol.
The color sliders* give you control over the RGB gains. It is
advisable to use the color sliders with a grey card to get good
color balance:
1. Frame the camera image on a neutral gray object. (A gray
card, piece of white paper, white wall etc.)
2. Turn on the histogram on the camera display.
3. Adjust the light or F-stop so that the histogram shows most
pixel values in mid range. You will see a separate peak for
Red, Green, and Blue. Green will likely be highest.
4. Adjust the gains for Blue and Red up so that the peaks
match the Green.
(* Color cameras only.)
6-7 Arm, Trigger, Live, and Review Buttons
Use the Arm, Trigger, Live, and Review
Bu
tt
ons above the image window to
control the state of the camera:
When the camera is in Live mode with
no captured images in its bu
ff
er, the
Arm
and
Live
bu
tt
ons will be enabled
(bright) and the Trigger and Review
bu
tt
ons will be disabled (grayed).
Click on the
Arm
bu
tt
on whenever it is
enabled and to go into Record mode.
This will arm the camera, recording the
pre-trigger frames.
The Arm bu
tt
on will now turn Brown
and change to “Armed.” The Trigger bu
tt
on will become enabled. Clicking on the
Armed
(brown) bu
tt
on, will de-arm the camera (a
ft
er a warning message), just like pressing the
mechanical Arm bu
tt
on on the camera while the camera is recording.
Clicking on the
Trigger
bu
tt
on (or using the external hardware trigger, if enabled) will cause the
Figure 6-10:
Display Settings Tab
Figure 6-11:
Arm, Trigger, Live and Review Buttons
T3 User Manual
Summary of Contents for eosens TS3
Page 1: ...User Manual 2013 3 110S 3000M eosens TS3 High Speed Handheld Camera...
Page 15: ...11S 3000M page 5 Figure 1 4 TS3 Side View Door open Figure 1 5 TS3 Bottom View T3 User Manual...
Page 105: ...TS3 User Manual Figure 10 4 High Mid and Low 8 Bits of the same Image...
Page 120: ...TS3 User Manual 11S 3000M page 111...