Mikrotron eosens TS3, User Manual, Page: 55 / 120

page 46 11S-3000M
Figure 6-8: Record Settings Tab--Advanced Settings
The Record Settings T ab, Advanced Settings x has one drop
down menu for Record Bit Depth and another for Fixed
Pa
tt ern Noise.
Select Bit Depth for Recording:
(See “4-4 Setting Bit D ep th” on page 25.)
Note that if 10 bits are selected for the recording, the
recording time will be shor t er, but you will have the added
fl e xibility of selecting which 8 bits t o view in Review or
Save. (The bit selection d r op down menu will appear in the
Display Settings T ab.
Select FPN Setting:
FPN selection (Disabled / Column FPN / Pi x el FPN) can be
done from the Web-Application via the Ad v anced Setting
menu, but Calibration mu s t be done from the camera. (See
“4-6 Black Level Calibration” on pa g e 27.)
6-5 Record Controls
The Record Controls Tab of the Web-App is shown in Figure
6-9 with the External Trigger, Sync In and Sync Out pull down
menus open.
Setting the Trigger Position:
The trigger position is s e t via slider. There is much finer
control of the trigger position using the w eb-App than can
be had on the camera GUI.
External Trigger:
Please refer to “Appendix D: Power and I/O Connections”
on page 82 for specification for all electrical connections,
including External Trigger, Sync In and Sync Out.
Select Rising Edge, or Falling Edge to enable the External
Trigger. Use Falling Edge for a simple switch closure.
Sync In and Sync Out:
NOTE: If Sync in is enabled you will not see any Live or
captured imagery unless there is a valid Sync In signal.
All of the options
f or camera synchronization a r e
selectable on this menu.
Please refer to “5 Synchronizing Cameras” on page 37
for detailed descriptions of the o
p tions
Figure 6-9: Record Controls Tab
T3 User Manual