Mikrotron Cube5 C, Instruction Manual

Page: 24 / 85

MotionBLITZ Cube User Manual Ver. 1.8.0 24
3.2.3 The network configuration file "mfggb.ini".
As mentioned in the paragraph above, "mfggb.ini" resides in the installation-directory
and contains 2 sections.
3.2.3.1 Section [CAMERA_REL]
This Section contains the MAC Address of the used camera and network adapter. The
addresses will be registered by the Cube control program; no changes are to be done
by the user.
Example:
AdapterMAC=00-0E-0C-4C-E2-F0
CameraMAC00=00-50-C2-1D-7E-20
Beside this, the camera’s IP-Address may be defined here. See above for details.
3.2.3.2 Section [IPORT_PARAMS]
##InterPacketDelay=2000 // single camera on a Labtop computer
##InterPacketDelay=6000 // camera is connected to an existing LAN
##InterPacketDelay=100 // Default
InterPacketDelay=3000 // Ethernet-switch
PacketSize=1440
RequestTimeOut=1000
PacketTimeOut=1000
AnswerTimeOut=1000
FirstPacketTimeOut=0
TabQuantity=2
COMDelay = 100 // in us
Depending on the system, use the appropriate parameter for the InterPacketDelay.
3.3 Connecting the MotionBLITZ Cube to the PC and starting program
To properly connect the camera to the PC please follow these steps:
1. connect the GigaBit Ethernet cable to the camera and then to the PC
2. connect the power supply to the camera
3. switch on the camera by pressing the power-switch
(see chapter Switches on page 10)
4. start the MotionBLITZ Cube Control programm. If it’s the first start after installa-
tion of the MotionBLITZ Cube software, two forms will be displayed for selecting
the GigaBit Ethernet adapter and the MotionBLITZ Cube camera. Please select
the network adapter, click on “Apply” and select the camera and click on “Apply”.
Now the MotionBLITZ Cube is ready to operate.
3.3.1 Selecting the network adapter