Mikrotron Cube5 C, Instruction Manual

Page: 16 / 85

MotionBLITZ Cube User Manual Ver. 1.8.0 16
1.9 Power supply and charging
MotionBLITZ Cube cameras contain an integrated, rechargable battery, which provides
the necessary voltage for operation. Use an external power supply for charging the bat-
tery and for external power operation.
*
Only voltages in the range from 10,5 to 24 Volts @ 15W max. are permit-
ted. Higher input voltages may seriously damage the camera. Damage of
this type is not covered by our warranty.
1.9.1 Battery charging
MotionBLITZ Cube contains an integrated, rechargable battery. Thus the camera can
operate as stand alone without any power connection for up to 30 minutes of circular
recording with full resolution.
For Cube4/5 cameras this time will be increased to 60 minutes.
Stored images can be retained in the camera up to two hours with a fully charged bat-
tery .
The battery will be automatically charged when the power supply (10,5 – 24 V DC) is
connected to the camera and the camera is switched off. Charging of a completely
empty battery will take 3 hours.
If the camera is switched on and a power supply connected, the battery is charged to a
fraction of its total capacity, it will operate a few minutes when disconnected from
power supply.
If the camera is switched on and a power supply is connected, the battery will be-
charged as well.
A fully charged battery will discharge within a few days when not used.
L
Always use an external power supply if the battery condition is unknown.