User’s manual for Repeater MRx01B Power
M0079A1A.doc
Id.-No. 151775
Page 30
10-March-00
The factory-set response after typing the software command STATUS EXTALARM is for
instance „EXT. ALARM 1 OK“, if the alarm is not active and „EXT. ALARM 1 FAILURE“,
if the alarm is active.
The name for each external alarm and the name for the alarm message can be defined by the
customer with the corresponding software command.
The following example describes the response for the external alarms to control an UPS.
Example:
External alarms if the UPS is active
EXTERNAL ALARM STATUS
UPS alarm active
Battery low !
UPS door open
Battery door open
or
External alarms if the UPS is not active
EXTERNAL ALARM STATUS
UPS not active
Battery OK
UPS door closed
Battery door closed
If the optional external alarms are part of the delivery, they will be switched on by a software
release, i.e. they are distributed via the software.
4.3 Modem
The Repeater can be equipped with a modem for the remote control of the repeater. This
allows the operator to change settings and querry information of the Repeater remotely.
See figure 4-2 for the optional modem kit. This kit is available with and without modem.
For information referring to the optional modem see chapter 4.4 and chapter 6.2.4.
