11
Water tank
Use water tank filled with water.
Useful life of blade depends on volume of cooling
water.
Pay attention to the water level.
(Fig.4)
Sprinkling pipe
Open the cock to make sure that sprinkler pipe is not
clogged.
(Fig.4).
Installing the blade:
Disconnect water pipe at the nipple of water tank side.
Remove the blade cover by lifting it upward.
Place flange (IN), diamond blade and flange (OUT)
around the blade shaft in such order, and install
washer before tightening sufficiently with nut (left-hand
thread). (Fig.5, 6)
After installing the blade, replace blade cover to base ,
before replacing water hose to nipple firmly. And
check the cooling water.
Cutting depth adjustment:
To unlock, set the knob to shallow groove.
This will enable you to exactly adjust the cutting depth
by turning the lifting handle.
To lower (feed motion) the machine body, rotate lifting
handle clockwise.
To raise the body, rotate the lifting handle counter-
clockwise.
When decided the cutting depth, set the knob at lock
position for lock the position of machine. (Fig.7)
4
5
6
a.
b.
Caution:
With wrench engaged at designated location of the
blade shaft to lock it, rotate nut counterclockwise to
tighten. (Fig.6)
Fig.4
c.
7
Water Tank
Blade cover
Water Cock
Fig.5
Flange(IN)
Diamond blade
Flange
(OUT)
Washer
Nut
Fig.6
27mm(L14)
Tightening
30mm(L14)
Fig.7
Raise
To lock the lift or lower the machine, set
the knob to deep groove.
To unlock, set the knob to shallow groove.
㻯㼞㼍㼚㼗㻌㻴㼍㼚㼐㼘㼑
㻌㻌㻌㻌㻌㻔㻯㼡㼠㼠㼕㼚㼓㻌㼐㼑㼜㼠㼔㻌
㻌㻌㻌㻌㻌㻌㻌㻌㼍㼐㼖㼡㼟㼠㼙㼑㼚㼠㻕
Lower
(Feed motion)
