QUICKGUIDE
OMEGA
3
YARD BASIC
1. Welding current, [A]
2. Wire feed speed, [m/min]
3. Welding voltage, [V]
4. Arc adjust
5. Lock symbol
Lock:
Insert the SD lock card and choose ”1”,
“2” or “All” using (11).
Unlock:
Reinsert the SD lock card to unlock
the control panel. For detail information,
see instruction manual.
6. Warning – Overheating
7. Fault indicator
See instruction manual
8. Display of wire feed speed or
welding current
15. Wire inching
Press the key to feed the wire and adjust
the wire feed speed by turning (10)
simultaneously.
1
BASIC III
A
V
61111425
8
10
1
2
9
11
3
4
14
13
12
6
7
9. Display of welding voltage or
Arc adjust
10. Setting wire feed speed or
welding current
Turn the control knob to set the desired
wire feed speed (MIG/MAG) (see table 1) or
welding current (MMA).
11. Setting welding voltage,
Arc adjust and welding process
Turn the control knob to set the desired
welding voltage or Arc adjust (see table 1).
Short press (11A) (MIG/MAG):
Change
between display of welding voltage and Arc
adjust.
Long press (11A):
Opens for setting the
welding process (see figure 1).
12. Selecting trigger mode
Change between 2-stroke (indicator off) and
4-stroke (indicator on).
2-stroke:
The welding process starts when
the torch trigger is activated and ends when
the torch trigger is released.
4-stroke:
The welding process starts when
the torch trigger is activated and released
and ends when the torch trigger is activated
again.
Long press:
Opens user menu. For detail
information, see instruction manual.
13. MMA welding
Press the key to choose MMA welding.
Long press recalls factory settings if indicator
is on.
14. MIG/MAG welding
Press the key to choose MIG/MAG welding.
Long press recalls factory settings if indicator
is on.
Program is optimised with regard to mix-gas
5
11A
15
