Problem solving guide
73
Fault messages after a programme has been cancelled
Problem
Possible cause and remedy
Drainage fault. Clean
drain filter and pump.
Check the drain
hose.
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
Clean the filters and the drain pump.
The maximum drain height is 1.0 m.
Water intake fault.
Turn on the tap.
The water inlet is blocked or restricted.
Check whether the tap is turned on properly.
Check whether the inlet hose is kinked.
Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
Clean the filter.
Fault F. If restart
fails, call Miele.
There is a fault.
Disconnect the washing machine from the mains
electricity supply, either by switching it off at the
wall socket and withdrawing the plug, or by
disconnecting it at the circuit breaker.
Wait
at least 2 minutes
before reconnecting the
washing machine to the mains electricity supply.
Then switch the washing machine on again.
Restart the programme.
If the fault message appears again, contact Miele.
Waterproof system
activated. Turn off
the tap. Call Miele.
The water protection system has reacted.
Turn off the tap.
Call Miele.
To switch off the fault messages: Switch the washing machine off with the
sensor.
