Problem solving guide
74
Fault messages at the end of a programme
Problem
Possible cause and remedy
Check detergent
Excessive foam has built up during washing.
Check the amount of detergent dispensed.
With automatic detergent dispensing, check the
dosage amount set.
Observe the instructions on the detergent
packaging and the degree of soiling of the laundry.
If necessary, reduce the dispensing quantity by
increments of 10%.
Hygiene info: Select
“Maintenance” and
start the “Clean
machine”
programme.
A wash programme using a temperature above 60°C
has not been run for a long time.
In order to prevent bacteria and unpleasant odours
building up in the machine, run the
Clean machine
programme using Miele IntenseClean or powder
detergent.
Check hot water
intake
The water inlet for hot water is blocked or turned off.
The programme was carried out using cold water.
Check whether the tap is turned on properly.
Check whether the inlet hose is kinked.
Check whether there is sufficient water pressure.
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the
OK
sensor.
