Fault messages
Repairs should only be performed by a
qualified technician in accordance with
applicable codes and standards. Repairs
and other work by unqualified persons
could be dangerous and the manufacturer
will not be held responsible.
Faults that occur before or after the start of a
program are shown in a flashing display.
PROGRAMME
1
COTTONS
PROGRAMME STOP
THROUGH POWER CUT
Please press the Start button.
^
When power is restored press
X
"Start".
This fault message can also indicate that the
winding protection of the drive motor has
overheated.
^
Allow the motor to cool down.
PROGRAMME
1
COTTONS
PROGRAMME STOP
WATER INLET FAULT
Open water stopcock and press Start button.
^
Open up the water stopcock (valve) and
press
X
"Start".
PROGRAMME
1
COTTONS
PROGRAMME STOP
DRAIN FAULT
Clean drain system and press Start button.
^
Check the drainage system on site and
press
X
"Start". A defective drain valve
should only be repaired by an authorized
service technician.
PROGRAMME
1
COTTONS
PROGRAMME STOP
HEATING SYSTEM FAULT
Short circuit on heater sensor 1.
^
Call the Miele Technical Service Depart-
ment.
PROGRAMME
1
COTTONS
PROGRAMME STOP
HEATING SYSTEM FAULT
Cut-out of heating sensor 1.
^
Call the Miele Technical Service Depart-
ment.
PROGRAMME
1
COTTONS
PROGRAMME STOP
HEATING SYSTEM FAULT
^
Call the Miele Technical Service Depart-
ment.
PROGRAMME
1
COTTONS
PROGRAMME STOP
DRIVE SYSTEM FAULT
Multiplug drive variants lacking.
^
Call the Miele Technical Service Depart-
ment.
PROGRAMME
1
COTTONS
95 °C
Main wash
20 °C
^
^^^^^^^^^
Rinses
1
DRIVE SYSTEM FAULT
^
Call the Miele Technical Service Depart-
ment if there is no drum movement after
this message.
PROGRAMME 1
COTTONS
PROGRAMME STOP
PEAK LOAD CUT OUT ACTIVE
At the end of the peak load cut out function
the program continues automatically.
PROGRAMME 1
COTTONS
PROGRAMME STOP
IMBALANCE SWITCH
Press the On-Off switch.
^
Press
Z
"Power off" and
Y
"Power on".
Problem solving guide
23
Summary of Contents for WS 5101
Page 29: ...Installation instructions ...