Fitting a plinth facing
The appliance plinth below the door
can be fitted with a plinth facing to
match your kitchen.
The height and return of the appliance
plinth cannot be altered.
Higher plinth can only be fitted if the
overall niche height is higher.
Plinth height
Niche height
100 mm
(standard)
820 mm
150 mm
870 mm
one raising kit is
required
200 mm
920 mm
two raising kits
are required
A plinth facing (600 mm long) can be
ordered from your Kitchen Dealer or
manufacturer. For Miele kitchens please
quote the model number of your ma-
chine when ordering.
Before fitting the plinth facing, please
note: Under no circumstances must
anything be stuck over the flap(s) in
the appliance plinth.
In order to open the drum door dur-
ing an emergency the plinth facing
must be removable.
Fitting the plinth facing:
^
Stick the velcro strip provided to the
appliance plinth.
For this the following procedure is rec-
ommended:
^
Match up the hooked side and the
looped side of the velcro strip length-
wise.
^
Cut it into 2 or 3 sections.
^
Peel the protective backing off one
side of the lengths of velcro.
^
Position the velcro strips along the
appliance plinth, at the left and right
hand sides and in the middle and
then press firmly into place.
^
Carefully remove the remaining pro-
tective foil from the velcro.
Press the plinth facing onto the adhe-
sive surface of the velcro strips and
press firmly into position.
Installation
56
