d
= Low water level
(
= Medium water level
e
= High water level
a
= Intensive rhythm
b
= Normal rhythm
c
= Gentle rhythm
d
= Sensitive rhythm
e
= Ultra sensitive rhythm
f
= Hand wash rhythm
This machine has fully electronic
controls with automatic load
recognition. It takes in the right amount
of water required for the programme
depending on the amount of laundry
and its absorbency rate. This means
that programme cycles and durations
can vary.
The programme sequences outlined in
the chart are based on the basic
programme with a full load. Extras
which can be selected have not been
taken into account.
The programme sequence display
shows the stage the programme has
reached.
Special features in the programme
sequences:
Anti-crease:
The drum will continue to rotate for up
to 30 minutes after the programme end
to avoid creasing. Exceptions: There is
no crease protection in the
Woollens
programme.
The washing machine door can be
opened at any time.
1)
Two rinses are carried out if a
temperature selected is between
60°C to 90°C. Three rinses are
carried out if the temperature
selected is below 60°C.
2)
A third or fourth rinse is carried out if:
– there is too much foam in the drum
– a spin speed lower than 700 rpm has
been selected
–
No
.
has been selected
3)
A third rinse is carried out if:
–
No
.
has been selected
4)
Laundry is only spun after the main
wash.
5)
Run-up to spin: A run-up to spin is
carried out before the wash process
begins to deflate pillows.
Subsequent water intake for the main
wash is through compartment
j
.
6)
Pre-rinse: A pre-rinse is carried out
automatically without detergent to
remove dust.
Programme sequence
39
