Imp
ort
Ap
plia
nce
s.c
om
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
Hob with frame or bevelled edge
56
Installation
Prepare the worktop
Create the worktop cut-out as shown
in the building-in diagram. Remember
to maintain the minimum safety dis-
tances (see "Safety distances").
Seal the cut surfaces with a suitable
heat-resistant sealant to avoid swell-
ing caused by moisture. The sealant
must be temperature-resistant.
Make sure that the sealant does not
come into contact with the top of the
worktop.
The seal under the appliance ensures
that the hob will sit securely in the cut-
out without slipping. Any gap between
the appliance frame and worktop will
become smaller over time.
Connect the mains connection cable
to the appliance
The mains connection cable must
only be connected by a suitably
qualified and competent person.
Follow the instructions in the wiring
diagram (see "Electrical connection -
Wiring diagram").
Install the hob
Feed the mains connection cable
down through the cut-out.
Place the hob centrally in the cut-out.
When doing this make sure that the
seal of the appliance sits flush with
the worktop on all sides. This is im-
portant to ensure an effective seal all
round.
Do not use any additional sealant
(e.g. silicone) on the hob.
If the seal does not meet the worktop
correctly on the corners, the corner ra-
dius (
≤
R4) can be carefully scribed to
suit.
Connect the hob to the mains.
Check that the hob works.
