^
the freezer section door has been
opened too frequently, or large
amounts of fresh food have been put
in at once for freezing.
^
the ventilation gaps are blocked.
^
there has been a lengthy interruption
to the power supply.
Once the problem has been resolved
the freezer section temperature display
will light up constantly and the alarm
will stop.
. . . a bar is lit up or flashing in the
temperature displays.
Check the temperature displays about
6 hours after switching on the
appliance. The display will not show a
temperature until the temperature in the
appliance has reached a certain level.
. . . the following appear in the
temperature display "
F0
" to "
F5
".
There is a fault. Call the Service
Department.
. . . "nA" appears in the temperature
display.
The freezer section temperature has
risen too high at some point during the
last couple of days because of a power
cut.
^
Press the alarm off button whilst "
nA
"
is lit up in the display.
The temperature display will show the
warmest temperature recorded in the
freezer section during the power cut.
Depending on the temperature
displayed, you should check the
condition of food in the freezer. If it has
defrosted or started to defrost check
that it is still safe to use, and if so, use it
as quickly as possible. Defrosted food
may only be re-frozen after it has been
cooked.
The warmest temperature will show in
the display for about 1 minute. The
actual current temperature in the
freezer section will then show in the
display again.
. . . you cannot switch the ice cube
maker on.
^
Check whether the appliance is
connected to the electricity supply.
. . . the ice cube maker is not
producing any ice cubes.
^
Was the water inlet pipe purged of air
by a qualified and competent person
before the appliance was used for
the first time?
^
Check whether the ice cube maker is
switched on.
^
Check whether the freezer section is
switched on.
^
Check whether the water inlet is
open.
^
Check that the ice cube drawer has
been closed properly.
Remember it can take up to 24 hours to
produce the first ice cubes.
. . . the indicator light on the ice cube
maker is flashing
There is a fault. Call the Service
Department.
Problem solving guide
36
