Miele G 7804, Operating Instructions Manual

Page: 60 / 76

Thermal cut-out
This machine has a resettable heater
limiter which will switch off the elements
in the event of over-heating. This could
be caused for example, by large
articles covering the heating elements
or if the filters in the wash cabinet are
blocked.
If the fault code: F01 - F02 ( water was
not heated up in the wash cabinet and
the programme is taking too long),
proceed as follows:
^
Remove the cause of the fault.
^
Open the service panel.
^
Press the reset button on the heater
limiter located on the right-hand side
of the plinth.
If this switch trips again, contact the
Miele Service Department.
Other problems
60