Miele G 7804, Operating Instructions Manual

Page: 54 / 76

Problem Possible cause Remedy
The Add salt indicator
light
k
flashes.
The salt reservoir has not
been replenished,
meaning that the water
softener could not be
reactivated. – Fill carefully with salt.
The neutralising agent
indicator light
w
flashes.
The neutralising agent
container is empty. – Fill the container with
neutralising agent or
replace it with a new, full
container.
– Vent the DOS module
where necessary.
The rinsing agent
indicator light
H
flashes.
The rinsing agent
reservoir is empty. – Fill the reservoir with
rinsing agent.
The liquid cleaning
agent indicator light
8
flashes.
The liquid cleaning agent
container is empty. – Fill the container with liquid
cleaning agent.
– Vent the DOS module
where necessary.
A few minutes after the
start of a programme,
the
p
/
6
indicator
flashes and the
programme is
cancelled.
Before trying to rectify the
problem, you must:
– Turn the programme
selector to
f
(the fault
code goes out).
– Switch the dishwasher off
with the I-0 switch.
Fault code: F..E :
There is a water inlet
fault.
– Open the stopcock.
– Clean the water inlet filter.
– The water pressure at the
intake is too low. Ask a
plumber for advice.
Then:
– Switch the dishwasher on.
– Start the programme
again.
Problem solving guide
54