Operation
70
End of programme
At the end of a programme, the optical
in-operation indicator light will flash
slowly with the door shut. The buzzer
might also sound.
The optical in-operation indicator light
will go out 10 minutes after the end of
the programme if the door is closed.
The programme has ended when the
display shows the message
Finished
.
In some programmes, if the AutoOpen
function is activated, the door will auto-
matically open slightly (see “Settings”
chapter, “AutoOpen” section). This im-
proves the drying process.
If the
Consumption
programmable func-
tion is switched on, you can now call up
the actual energy and water consump-
tion of the programme that has just fin-
ished (see “Caring for the environment”
chapter, “EcoFeedback consumption
indicator” section).
The drying fan may continue to run for
a few minutes at the end of the pro-
gramme.
Risk of damage due to steam.
Steam from the dishwasher could
damage the edges of delicate work-
tops when you open the door at the
end of the programme if the fan is no
longer running.
If you have deactivated the auto-
matic door opening function (see
“Settings” chapter, “AutoOpen” sec-
tion), but would still like to open the
door at the end of the programme,
then make sure that you open the
door fully.
Energy management
To save energy the dishwasher will
switch off automatically 10 minutes
after the last time a sensor control is
pressed or after the end of a pro-
gramme.
You can switch the dishwasher back on
again with the
sensor control.
If the dishwasher has been switched off
for longer than 1 minute, you will need
to hold the
sensor control for a bit
longer (wipe protection).
The dishwasher will not switch itself
off whilst a programme is running or if
there is a fault.
