Miele G 6820, Operating Instructions Manual

Page: 75 / 112

Problem solving guide
75
General problems
Problem Cause and remedy
The interior lighting
does not come on when
the door is opened. The lighting has been switched off permanently.

Switch the lighting back on again (see "Settings
menu, BrilliantLight").
The following fault mes-
sage is appears in the
display:

Salt reservoir lid
The salt reservoir lid has not been closed properly.

Close the salt reservoir lid.
If the salt reservoir lid has opened during a pro-
gramme:
 Switch the dishwasher off and back on again with
the

button.
 Close the salt reservoir lid.
 Start the programme again.
Detergent residue is left
in the dispenser at the
end of a programme. The dispenser was still damp when detergent was ad-
ded.
 Make sure the dispenser is dry before adding de-
tergent.
The detergent dis-
penser lid cannot be
closed properly. Clogged detergent residue is blocking the catch.

Clean the detergent from the catch.
At the end of a pro-
gramme there is a film
of moisture on the in-
side of the door and the
interior cabinet walls.
This is caused by the drying system and does not in-
dicate a fault. The moisture will dissipate after a
while.
Water remains in the
wash cabinet at the end
of a programme. Before rectifying the problem:
 Switch the dishwasher off with the  button.
The filter combination in the wash cabinet is clogged.

Clean the filter combination (see "Cleaning and
care, Cleaning the filters").
The drain pump or non-return valve may be blocked.

Clean the drain pump or the non-return valve (see
"Maintenance").
The drain hose is kinked.

Remove any kink from the drain hose.