Programming and setting the
water hardness level
The water hardness level of your water
supply must be programmed into the
dishwasher using the buttons on the
control panel. The water hardness
selector in the wash cabinet is then also
set to the water hardness level in your
area.
Programming and changing the
water hardness level
The water hardness level which has
been programmed into the machine
can be checked and adjusted by using
the buttons on the control panel.
^
Turn the appliance off with the
“On/Off” button.
^
Press
$
and “Start” simultaneously
and at the same time turn the dish-
washer on using the “On/Off” button.
A “P” and 2 figures will appear in the
time display.
^
Turn the program selector to “Sani
Wash”.
The value corresponding to the pro-
grammed water hardness level e.g.
“22” will appear in the time display.
The water hardness level is 22 gr/gal
(400 ppm).
If the water hardness level in memory is
the correct one:
^
Turn the appliance off with the
“On/Off” button.
If you wish to program a different water
hardness level:
^
Press the “Top Solo” button repeat-
edly until the value corresponding to
your water hardness level appears in
the display. This figure will be in
gr/gal. For instance if your water
hardness level is 30 gr/gal (540 ppm)
then the figure “30” will show in the
display.
Note:
Once the figure “36” is reached the
counter returns to “1”.
^
Press the “Start” button.
“SP” appears in the time display.
^
Press the “Start” button again.
The new water hardness level is stored
in memory.
The running time of the program which
the selector dial is set to is now shown
in the display in hours and minutes.
The “Time Left” indicator next to the
time display lights up.
^
Turn the program selector to the
“Stop” position.
^
Turn off the dishwasher with the
“On/Off” button.
Before using for the first time
14
