Installation
*INSTALLATION*
83
A faucet with a 9/16" male thread must
be provided on site. If this type of
faucet is not available, only a qualified
installer may connect the dishwasher to
the domestic water supply.
A backflow preventer is not required.
The appliance meets the requirements
of the applicable DIN standards.
The water connection pressure needs
to be between 50 and 1,000 kPa. If the
water connection pressure is too high, a
pressure reducing valve must be fitted.
Risk of damage from leaking
water.
The connection point is subject to
water pressure. Water leaking from it
can cause damage.
You should therefore open the faucet
slowly and check for leaks. Correct
the position of the seal and screw
thread if appropriate.
Risk of damage due to excessive
pressure.
A brief increase in the water pressure
can damage components of the
dishwasher.
This dishwasher must only be
operated when it is connected to a
fully primed plumbing system.
Risk of damage from leaking
water.
The intake hose is under water
pressure.
The intake hose must not be
shortened or damaged in any way.
Do not sit the dishwasher on the
hose. The hose needs to be free of
kinks and able to move freely after
installation. Do not place the hose or
power cord next to a heat source
e.g., hot water pipes. Do not expose
the hose or power cord to corrosive
substances (e.g., chloride). Damage
to the hose or power cord could
cause electrical shock or water
damage.
