Drilling holes in the furniture
front panel for the switching
unit
Use the drilling template supplied
e
to
drill the holes for the switching unit in
the furniture front panel.
Drill 3 holes through the front panel,
working from the front as follows:
a
for the switching unit spindle
b
for the yellow indicator light
c
for the red indicator light
To secure the switching unit, make
4
pilot holes
d
in the front panel
working from the rear
.
Important:
Humidity may cause variation in the
size of the drilling template.
Please check the dimensions
before drilling.
On a 40 mm thick worktop place the
drilling template
e
so that it is flush
with the underside of the worktop (see
illustration).
The gap between the underside of the
worktop and front panel should be
5 mm.
CT 400 P installation instructions
24
Summary of Contents for CT 400 MP
Page 5: ...CT 400 MP dimensions Description of the appliance 5 ...
Page 32: ...32 ...
Page 33: ...33 ...
Page 34: ...Alteration rights reserved xx06 M Nr 06 760 290 02 en ...
