Miele CT 400 MP, Operating And Installation Instructions

Page: 20 / 34

Safety instructions for
installation
Fit wall units and extractor hood
before fitting the tepan to avoid
damaging the surface.
The veneer or laminate coatings of
worktops (or adjacent kitchen
units) must be treated with 100 °C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of
heat-resistant material.
This equipment may only be used
in mobile installations such as
ships, caravans, aircraft etc. if a risk
assessment has been carried out by a
suitably qualified engineer.
Connection should be made via a
suitable isolator or a double pole
fused spur connection unit which
complies with current national and local
safety regulations and the on/off switch
should be easily accessible after the
appliance has been built-in. See
"Electrical connection - Built-in Tepan"
for more details.
The appliance must not be built in
over a fridge, fridge-freezer,
freezer, dishwasher, washing machine
or tumble dryer.
After installation, ensure that the
connection cable cannot come into
contact with the underside of the
appliance. Make sure that there is no
mechanical obstruction, such as a
drawer, which could damage it.
A protective shelf should be fitted
underneath the appliance to
ensure that the underside of the
appliance cannot accessed or touched
once it has been installed (see
"Protective shelf").
Observe carefully the safety
distances given on the following
pages.
Do not use any sealant except
where expressly instructed to do
so. The seal underneath the appliance
provides a sufficient seal for the
worktop (see "Sealant").
All dimensions in this instruction booklet
are given in mm.
CT 400 P installation instructions
20