Installing the appliance(s)
^
Starting at the front, position the
building-in frame in the worktop
cut-out.
^
Using both hands, press down
evenly on the sides of the building-in
frame until it clicks into position.
When doing this make sure that the
seal sits flush with the worktop on all
sides. This is important to ensure an
effective seal all round.
Do not use
sealant.
^
Push the appliance to the side until
the holes in the spacer bar can be
seen.
^
Fit the cover strip
d
into the holes in
the spacer bar
b
.
^
Starting at the front, position the next
appliance in the worktop cut-out.
Once installed, the building-in frame
can only be removed using a special
tool.
It can also be pushed up out of the
cut-out from below. It must be
pushed up from the back first.
en-GB
16
Summary of Contents for CS 1418
Page 75: ...75 ...
Page 76: ...0112 M Nr 07 228 840 03 ...
