Miele Blizzard CX1 SKCR3, Operating Instructions Manual

Page: 100 / 112

24
The suction power setting  will flash
in the vacuum cleaner display.

Press the ComfortClean button on
the vacuum cleaner for at least four
seconds.
The vacuum cleaner can continue to be
used in this way, but only at maximum
power.

Undo the screw on the battery com-
partment cover using a cross-tip
screwdriver and then remove the
cover.
 Replace the battery with a new one,
making sure the polarity is correct.
 Replace the cover and tighten the
screw back up again.

Dispose of the old battery in a muni-
cipal recycling facility.
When to change the thread lifters
(not possible on EcoTeQ Plus floor-
heads)
The thread lifters on the suction inlet to
the floorhead can be replaced. Check
them from time to time and replace
them if the pile has worn down.
How to replace the thread lifters

Use a suitable screwdriver to remove
the thread lifters from the slots.

Fit new thread lifters.
Cleaning the roller on the AllTeQ
floorhead

Release the bearing (with bayonet fit-
ting) using a coin.

Press the bearing out, and remove.

Remove the roller.