Midway 40272, Game Operations Manual

Page: 45 / 93

To service the Dashboard PCB.. .
Refer to the
Dash PCB
S e r v i c e i l l u s t r a t i o n
Switch off the power to the game machine and unplug the AC line cord.
Remove the Dashboard and the Center Control Pod. Refer to service
Dashboard and fhe Center Control Pod.
With the Center Control Pod removed from the dash, remove 5 hex head screws that are
used to fasten the PCB to the pod and set aside.
Remove the ribbon and power cable connections.
Perform the desired repair or equipment replacement.
Connect the ribbon and power cable to a Dashboard PCB. NOTE: The red stripe on the
ribbon cable must be up with pin 1 on the PCB, and the black wire on the power
cable must line up with pin 1 on the power connection for the Dashboard.
Re-attach the PCB to the pod, and then fasten the pod to the dashboard.
Check for pinched wires.
Re-install the Dashboard and fasten in place with the screws
To service the Left or Right Control Pods...
Refer to the
Control Pod, Buttons and Shifter
Service illustration.
Switch off the power to the game machine and unplug the AC line cord.
Remove the 4 tamper-resistant buttons used to fasten the faceplate.
Pull the plate forward enough to expose the switches.
Label and disconnect the wiring for the pod(s) being serviced.
3 Lift the buttons orshifter mechanism out of the pod and set aside.
Remove the 2 hex head screws used to fasten the pod to the dash, and then gently
the pod off the dashboard.
Perform the desired repair or equipment replacement.
Be-install and fasten rn place wrth the screws provided.
8