Midway 40272, Game Operations Manual

Page: 52 / 93

Seat Pedestal Service
To service the Seat Slide Assembly...
Refer to the Seal S e r v i c e i l l u s t r a t i o n .
Switch off the power to the game machine and unplug the AC line cord.
Disconnect the Seat Assembly from the cabinet by removing 8 tamper resistant screws
used to fasten the assembly to the slide rails in the cabinet.
3 Slide the Seat Assembly halfway back along the rails to expose wiring.
3 Disconnect the speaker cable and slide the seat the rest of the way off the rails.
Remove 3 tamper resistant screws from each side of the seat mounting plate. the
seat and mounting plate assembly off the pedestal and set aside.
Slide the seat assembly forward, and remove the two tamper resistant screws from the
rear of the metal panel on top of the pedestal assembly.
Slide the seat assembly backward and remove the two tamper resistant screws from
the front of the metal panel.
Lift the metal panel out of the pedestal base and turn the unit over.
3 Remove the four nuts holding the metal panel to the slide assembly. Set the metal
p a n e l a s i d e a n d s l i d e a s s e m b l y i s e x p o s e d .
Perform the desired repair or equipment replacement.
Reinstall by performing the steps in reverse and fasten in place using the hardware
provided.
IMPORTANT: Apply removable anaerobic adhesive thread lock (Loctite Blue 242 or
and torque each bolt to seven to nine (0.7 to Nm) if w a s l o o s e n e d
(see Illustration).
Service 16