Just the Facts for the Classic Lite (continued)
19 |
P a g e 1 0 - 2 0 8 - 1 R E V : A
Troubleshooting
Classic Lite will not power
on. “No self test on power
up”
*Check for voltage between the B and the common – on the blue
terminal block inside the Classic. If voltage is present and above 10vdc contact
customer service. If no voltage is present back step through the + and – to find
the fault.
*Contact Customer Service
MNLP has all LED’s
Flashing slowly
*Check that the blue cable is plugged in between the MNLP and the top most
jack on the circuit board.
*Try another cable. A standard short 4 conductor phone cable will work.
*Contact Customer Service
MNLP has the 3 Status LED’s
Flashing slowly
*This indicates the “Wrong Code” has been installed please re install the
firmware and select the correct Classic model.
*Contact Customer Service
There was no “Jumper” present
to install for Ground Fault
Protection
*There will be 4 more Jumpers just above the Blue DC Terminal block. One of
these can be used to replace the GFP jumper
*Contact Customer service for a replacement Jumper
The Green Float Status LED
blinks slowly even when there
is sun available
*Verify that all Switches 1 through 7 in Section 1 are all set correctly
*Verify DC voltage on the Blue DC Terminal blocks PV+ and Common –
terminals that is greater than the Battery voltage
*Contact Customer Service
The Classic Lite does not show
up on the Networked Classic’s
MNGP as Classic2
*Check that the Jumper for Network addressing is installed as shown on page 16
*Verify the Network Cable is installed correctly as shown on page 16
*Try another Network Cable
*Contact Customer Service
The Standard Classics MNGP
says Unused Address
* There are currently over 100 possible “Addresses” in the MNGP that can be
accessed by holding the left arrow and tapping the up and down arrows. If you
get “Lost” Just head up or down until you find your Classic (Address 10) and
Classic2 (Address 11)
YOUR
MIDNITE SOLAR
DISTRIBUTOR
SOLIGENT
800-967-6917
www.soligent.net
