Control System
(14)OK button
Used to confirm the time setting and modification.
(15)COOL/HEAT (inner located)
Press this button with a needle of 1mm to shift mode between COOL only and COOL&HEAT.
During setting, backlight will be lightened. Factory default mode is COOL &HEAT.
(16)ECO Button
Activate or turn off economic operation mode. It is suggested to turn on this function when sleeping. (Only
available when remote controller is used with corresponding unit.)
1.2.2 LCD display
Notes:
RM05/BG(T)E-A is able to set the indoor units’ addresses individually.
1.2.3 How to set address through Wireless Remote Controller RM05
●
Press the LOCK button for more than 5 seconds, then the controller gets into address setting mode.
●
Press the ON/OFF button to start transmitting signal in the address setting mode. If the transmitting signal
icon has been turned on, then step can be omitted. When working in address setting mode, press ON/OFF
will not turn the controller off.
●
In the address setting mode, there are 2 main functions:
Querying address: Please point the remote controller to the indoor unit, then press MODE button, the
corresponding indoor unit will display its address.
Setting address: Use the UP and DOWN buttons to choose an address you want. Then point the remote
controller to the indoor unit and then press the FAN button to set the indoor unit’s address. The
corresponding indoor unit will display the new address and record it. After about 4 seconds, this displaying
will fade out and the indoor units turn to normal display mode.
Note:
the address cannot be repeated in the same system
●
After setting all the addresses, users can press the LOCK button for 5 seconds to exit the address setting
mode.
