Midea MW120WWBA2RC1, Operator'S Manual

Page: 5 / 72

User Manual Page 5
Power supply cord with 3-prong
grounding plug and current
detection device
Do not, under any
circumstances, cut,
remove or bypass
the grounding prong.
Grounding type wall receptacle
WARNING - For your safety
• Do not store or use gasoline or other
ammable vapors and liquids in the vicinity
of this or any other appliance.
re hazard or electric shock. Do not
use an extension cord or an adaptor plug.
Do not remove any prongs from the power
cord.
WARNING - Prevent Accidents
re, electrical shock,
or injury to persons when using your air
conditioner, follow basic precautions,
including the following:
• If the air conditioner is to be installed in
a window, you should clean both sides of
the glass ÿrst. If the window is a triple-
track type with a screen panel included,
remove the screen completely before
installation.
• Be sure the air conditioner has been securely
and correctly installed according to the
installation instructions in this manual.
Save this manual for possible future use in
removing or installing this unit.
The complete electrical rating of your new room
air conditioner is stated on the rating label.
Refer to the rating when checking the electrical
requirements.
• Be sure the air conditioner is properly
grounded. To minimize shock and ÿre
hazards, proper grounding is important.
The power cord is equipped with a three-
prong grounding plug for protection
against shock hazards.
• Your air conditioner must be used in a
properly grounded wall receptacle. If the
wall receptacle you intend to use is not
adequately grounded or protected by a time
ed
electrician install the proper receptacle.
• Ensure the receptacle is accessible after the
unit installation.
• Do not run air conditioner without outside
protective cover in place. This could result
in mechanical damage within the air
conditioner.
WARNING - Electrical Information
NOTE
The power supply cord with this air
conditioner contains a current detection
re.
Please refer to the section Power Cord
Operation for details.
In the event that the power supply cord is
damaged, it can not be repaired. It must be
replaced with a cord from the manufacturer.
Saf
et
y
Precautions