Midea MW120WWBA2RC1, Operator'S Manual

Page: 17 / 72

User Manual Page 17
indicator light illuminates. It indicates the Auto
Stop program has initiated.
TO SELECT THE OPERATING MODE:
To choose operating mode, press Mode button.
Each time you press the button, a mode is selected
in a sequence that goes from Auto, Cool, Dry and
Fan. The indicator light adjacent will be illuminated
and remain on once the mode is selected.
power button, the unit will automatically switch on
the Energy Saver function for the following modes:
Cool, Dry, Auto.
To operate on Auto feature:
-
When you set the air conditioner to AUTO mode,
it will automatically select cooling or fan only
operation depending on what temperature you
have selected and the current room temperature.
- The air conditioner will control room
temperature automatically according to
temperature you’ve set.
- In this mode, the fan speed cannot be adjusted
as it’s automatically controlled according to
temperature setting and room temperature.
To operate on Fan Only:
-
Use this function only when cooling is not
desired, such as for room air circulation
or to exhaust stale air (on some models).
(Remember to open the vent during this
function, but keep it closed during cooling for
ciency.) You can choose
any fan speed you prefer.
- During this function, the display will show
the actual room temperature, not the set
temperature as in the cooling mode.
- In Fan Only mode, the temperature is not
adjusted.
To operate on Dry mode:
-
In this mode, the air conditioner will generally
er. Since the
conditioned space is a closed or sealed area,
some degree of cooling will occur.
TIMER: AUTO START/STOP FEATURE:
When the unit is on, press the Timer
light will illuminate indicating the Auto
stop feature has been activated.
button. The “Timer on” LED indicator
light will illuminate indicating the Auto
start feature has been activated.
- When the time of TIMER ON is displayed,
press the Timer button again. The TIMER OFF
-
Press or hold the UP or DOWN button to
change the Auto time by 0.5 hour increments,
up to 10 hours, then at 1 hour increments up to
24 hours. The control will count down the time
remaining until start.
- The selected time will register in 5 seconds,
and the system will automatically revert back
to display the previous temperature setting or
room temperature when the unit is on. (when
, there is no display.)
- Turning the unit ON or OFF at any time or
adjusting the timer setting to 0.0 will cancel
the Auto Start/Stop timed program.
Oper
ating
Instruc
tions
Displays
DISPLAYS:
Shows the set temperature in “°C” or “°F” and the
Auto-timer settings. While on Fan Only mode, it
shows the room temperature. If the room temperature
is too high or low, it will display"HI" or "LO"
Error codes:
AS
- Room temperature sensor error - Unplug the
unit and plug it back in. If error repeats, call
for service.
ES - Evaporator temperature sensor error -
Unplug the unit and plug it back in. If error
repeats, call for service.
DISPLAYS
NOTES
To cancel timer operation, press and
hold the timer button for 2 seconds until the
beep/buzzer is heard.
NOTE
• To change the AC between Celsius and
Fahrenheit scales, press the temperature
control arrows at the same time for 5
seconds.
• If the unit shuts o unexpectedly due to
the power outage, it will restart with the
previous function setting automatically
when the power resumes.