![background image](http://html1.mh-extra.com/html/midea/jl1645t-z/jl1645t-z_instruction-manual_1791843006.webp)
5
1) Push tubing through collet until it engages the o-ring. Continue pushing until the tube bottoms
out against the back of the fitting. A common mistake is to stop pushing when the tube
engages the o-ring. This will lead to future leaks. When a 3/8” tubing is fully engaged, 20 mm
of the tube has entered the fitting (Figure 4).
2) If using tubing other than that supplied with the system, be sure it is of high quality, exact size
and roundness with a smooth surface.
Connect tubes:
Disconnect tube:
Collet
Collet
O-ring
Figure4
Tube partially engaged with fitting
Tube fully engaged with fitting
1) Push the collet inward with finger tips and hold it.
2) Pull the tubing out.
5. Take out the quick joint, and install it on the water pipe.
Tap water
(1)
(2)
3/4'' internal
screw thread
1/4'' PE pipe
connector
PE pipe
6. Filter should be cleaned for the first use. Remove the top cover, take out the filter and then
connect to PE tube (press IN for let water in, OUT for outlet water). Turn on the faucet to flush
the filter for 10 minutes, and then install it back to the machine, and placed the filter according
to the serial number.
Inlet
Outlet
Water flow
Summary of Contents for JL1645T-Z
Page 11: ......