4
PP & Carbon
block filter
UF membrane
filter
2-5 Filter function introduction
2. Circuit diagram
M
E N L
T
T
solenoid valve 1
solenoid valve 4
solenoid valve 5
solenoid valve 3
solenoid valve 2
display board
heating NTC
cooling NTC
compressor
FUSE
power board
Leakage
detection boar
UV lamp
cooling switch
heating switch
bimetal 2
bimetal 1
heater
220-240V IN
Function
Filter
Stage
Stage 2
Stage 1
Carry out coarse filtration of original water, and filter out mud, sand,
impurity, iron rust and suspension, etc.
Absorb unusual colors and odors, Remove residual chlorine and
organic substances in water.
Remove bacteria, iron rust, colloids and
impurities in water
3. Use Guide and Maintenance
WARNING:
Please cut off water source before replacing filters. Never plug filters in water running
state.
3.1 Guidance on Unpacking and Installation
1. Open the top of the packing case, take out the top foam and its accessories.
2. Put the accessories aside.
3. Unpack the product, install the water collector.
4. Before installation, To study the use of the quick connector.
Connect the tubing
The system includes push-in fittings for quick tubing connection. Review the following
instructions before connecting the tubes in the next step.
1) Use a sharp cutter or knife to cut the end of tubing. Always cut the tubing square.
2) Inspect the end (about 30 mm) of the tubing to be sure there are no nicks, scratches or other
rough spots. If needed, cut the tubing again.
Cut tube to length:
Summary of Contents for JL1645T-Z
Page 11: ......