1. When setting the date of each function, long press on " + " or " - " for more
than 3 seconds,
2. When setting each of the time function, if there is none operation for 5 inutes
then it will return to manual mode.
3. When setting each of the time function, pressing on " " for more than 3
seconds can cancel current setting and enter manual mode.
4. During time function setting, pressing on " + " and " " for more than 3
seconds a beep sounds it can cancle the curent time function setting and
enter standby mode.
5. We suggest that you run the oven elements for 15 minutes at 200 degrees to
burn off any residuce from their surfaces.
The oven will start operating at the time calculated by deducting the cooking
period from the set finishing time, and will stop at the set finishing time. The
timer will give an audible warning and the symbol "A" will begin to flash.
After bringing the cooking function and oven temperature knob to " 0 " position.
Pressing any button less than 3 seconds, it will stop the audible warning.
Pressing " " for more than 3 seconds set the oven to Manual mode again to
use the oven.
Please note: Once setting full-automatic mode all the, time can not be changed
Change. Time means cancle automatice progamme and enter into corresponding
mode. If you need to reset automatic mode, need to stop setting the current
mode to set the automatice mode according to the above steps again.
Spectification
date will progressively and rapidly increase or decrease.
the
EN-16