Microtronics myDatalogEASY V3, User Manual

Page: 27 / 278

Chapter 4 General specifications
4.11 Warranty
The device has been functionally tested before delivery. If it is used as intended (see "Intended use" on page
24) and the operating instructions, the applicable documents (see "Applicable documents " on page 77) and
the safety notes and instructions contained therein, are observed, no functional restrictions are to be
expected and perfect operation should be possible.
Note: Please also note in this regard the next chapter "Disclaimer" on page 27.
Note: Limitation of warranty
In the event of non-compliance with the safety instructions and instructions in this document, the
manufacturer reserves the right to limit the warranty.
4.12 Disclaimer
The manufacturer assumes no liability
l
for damages owing to a change of this document. The manufacturer reserves the right to change the
contents of this document and this disclaimer at any time and without any notice.
l
for damages to persons or objects resulting from failure to comply with applicable regulations . For
connection, commissioning and operation of the devices/sensors all available information and higher
local legal regulations (e.g. in Austria ÖVE guidelines) such as applicable Ex regulations as well as
safety requirements and regulations in order to avoid accidents shall be adhered to.
l
for damages to persons or objects resulting from improper use . For safety and warranty reasons, all
internal work on the instruments beyond from that involved in normal installation and connection, must
be carried out only by qualified Microtronics personnel or persons or companies authorised by
Microtronics .
l
for damages to persons or objects resulting from the use of instruments in technically imperfect
condition.
l
for damages to persons or objects resulting from the use of instruments not in accordance with the
requirements .
l
for damages to persons or objects resulting from failure to comply with safety information
contained within this instruction manual.
l
for missing or incorrect measurement values or resulting consequential damages due to improper
installation .
4.13 Obligation of the operator
WARNING:
In the EEA (European Economic Area), the national implementation of the framework
directive (89/391/EEC) as well as the associated specific directives and from these in
particular, the directive (2009/104/EC) about the minimum safety and health requirements
for use of work equipment by workers at work, each in their respective version are to be
complied with.
The operator must obtain the local operating licence and the associated documents.
Rev. 05 27