7
7.
Once it reaches the end stop it will display ‘Set Open’.
Press and hold down
PB
or button
1
on a coded remote. Drive the gate to the open
position, if you go too far you can rotate dial to ‘Drive Motor Close’ or use button
2
on
a remote.
set open
set open
0
0
opening
opening
239
239
open pos set
open pos set
closing
closing
0 5 A 3 0 a
0 5 A 3 0 a
8.
Once gate reaches the closed position ‘Setup Complete’ will display, then after 2 seconds
the main screen will display.
system closed
system closed
12 9 volts
12 9 volts
setup
setup
complete
complete
After motor has been stationary for 10 seconds, the screen will display ‘Open Position Set’.
Once gate board has stored the closed position, the gate will close displaying run current
on the left and trip current on the right.
