migra MPB PB
Large Format, Graphics Compatible Display with Profibus Interface
Page 19
microSYST Systemelectronic GmbH, Am Gewerbepark 11, 92670 Windischeschenbach
+49 9681 91960-0,
+49 9681 91960-10, [email protected], www.microsyst.de
If the bargraph is not displayed yet, this will be done automatically now.
The bargraph-bar will be displayed corresponding to its position between
the MIN- and MAX-borders which are defined within the configuration.
The bar always starts at the configured reference value. It ends at the
position of the transmitted value.
The bar will be shown with its configured colour at the position of the
reference value.
If the bar exceeds one of the colour-borders (starting at the reference
value), it will be shown in the new defined colour after this point.
Four colour-borders are defined. Each of them must be in the range
MIN-border to MAX-border:
MIN-border <= colour-border 1 <= colour-border 2 <= colour-border 3 <=
colour-border 4 <=MAX-border
The PC-software ensures this rule !
Beside showing the standard bargraph (multi-coloured bar), it is also
possible to show it as a single-coloured bar or as a single-coloured mark
(depending on the configuration data - see PC-software).
The colour of the single-coloured bar / mark is the same as the colour of
the end-position of the standard bar.
If the current value is not in the range “MIN-border” to “MAX-border“, a
blinking mark will be shown at the particular border.