Microsens Media Converter/Signal Repeater Module, User Manual, Page: 13 / 29

Media Converter/Signal Repeater page 13/29
NAME DESCRIPTION ACTION
ms430580mAlmLine2TxBiasLowAla TRSCV 2 Bias Low: Alarm
indicating that the transceiver
laser bias current of Line 2 is
lower than the threshold value
written in the transceiver
EEPROM Correlate all Alarms. Carry out
necessary maintenance
procedures.
ms430580mAlmLine2TxBiasHighAla TRSCV 2 Bias High: Alarm
indicating that the transceiver
laser bias current of Line 2 is
higher than the threshold value
written in the transceiver
EEPROM Correlate all Alarms. Carry out
necessary maintenance
procedures.
ms430580mAlmLine2TempLowAla TRSCV 2 Temp Low: Alarm
indicating that the transceiver
temperature of Line 2 is lower
than the threshold value written
in the transceiver EEPROM Correlate all Alarms. Carry out
necessary maintenance
procedures.
ms430580mAlmLine2TempHighAla TRSCV 2 Temp High: Alarm
indicating that the transceiver
temperature of Line 2 is higher
than the threshold value written
in the transceiver EEPROM Correlate all Alarms. Carry out
necessary maintenance
procedures.
ms430580mAlmLine2RxPwrLowAla TRSCV 2 Rx Power Low: Alarm
indicating that the transceiver
input power of Line 2 is lower
than the threshold value written
in the transceiver EEPROM Correlate all Alarms. Carry out
necessary maintenance
procedures.
ms430580mAlmLine2RxPwrHighAla TRSCV 2 Rx Power High: Alarm
indicating that the transceiver
input power of Line 2 is higher
than the thresholdvalue written in
the transceiverEEPROM Correlate all Alarms. Carry out
necessary maintenance
procedures.
ms430580mAlmLine2TrscvAbsent Line 2 SFP not plugged: This
OID indicates that the
transceiver module 2 is not
present Plug in the Optical Module. If
Alarm
persists change the optical
component.
ms430580mAlmLine2TrscvDdmAbse
nt DDM supported on Line 2 SFP: This
OID indicates that the
transceiver module 2 does not
support Digital Diagnostic
Monitoring Functions If SFP supports DDM change the
SFP, else ignore.
ms430580mAlmLine2HwFail Line 2 HW Failure: This OID
indicates a hardware failure on
the Line 2 Correlate relevant alarms. Carry
out
necessary maintenance
procedures.
ms430580mAlmLine2TrscvLsd Line 2 SFP optical TX ON: This
OID indicates the optical output
power is off on Line 2 No action information only.
ms430580mAlmLine2TrscvDdmWarn
ing Warning DDM on OpticalModule
2: This OID indicates awarning is
present coming outof optical
interface DDM onLine 2 Correlate all warnings. Carry out
necessary maintenance
procedures.
ms430580mAlmLine2TrscvDdmAlm Alarm DDM on Optical Module 2:
This OID indicates an alarm is
present coming out of optical
interface DDM on Line 2 Correlate all alarms. Carry out
necessary maintenance
procedures.
MICROSENS GmbH & Co. KG - Küferstraße 16 - 59067 Hamm - Tel. +49 2381/9452 0 - Fax 9452 100 - www.microsens.com