Copyright © July, 2011
Microsemi
Page 6
Rev.A03
Analog Mixed Signal Group
2381 Morse Avenue, Irvine, CA 92614, USA; Phone (USA): (800) 713-4113, ROW: (949) 221-7100 Fax: (949) 756-0308
2 Safety Information
Read the following safety information before using your Power over
Ethernet Midspan unit.
2.1 General
Guidelines
Read the following safety information before carrying out any installation,
removal, or maintenance procedure on the Power over Ethernet Midspan.
Warnings contain directions to be followed for the safety of personal and
product. Follow all directions carefully.
2.2 Warnings
Read installation instructions in Section
4 before
connecting Power over Ethernet Midspan to its power
source.
Read instructions in Section
4 before connecting
Midspan-to-Midspan power backup.
Midspan must use a grounded power cord, as defined in
Section
2.3.
This product relies on the building installation for short-
circuit (over-current) protection. Use only a fuse or circuit
breaker not higher than 15A for 120VAC (U.S.), or 10A
for 230VAC (international).
Do not work on the system, connect, or disconnect
cables during periods of lightning.
A voltage mismatch can cause equipment damage and
can pose a fire hazard. If voltage indicated on the label is
different from power outlet voltage, do not connect Power
over Ethernet Midspan to this outlet.
For shelf-mounted equipment, verify surface is stable and
strong enough to support equipment. Do not stack more
than
four
Power over Ethernet Midspan units.
When disposing this product, follow all local laws and
regulations.
