Power Over Ethernet Power View Pro User Guide
Copyright
2013
Microsemi
19
Rev.1.0, 17-Dec-13
Analog Mixed Signal Group
1 Enterprise, Aliso Viejo, CA 92656, USA; Phone (USA): (800) 713-4113, (ROW): (949) 221-7100 Fax: (949) 756-0308
SNMPv3 Authentication
and Encryption Mode
None
– no authentication or encryption (no security - equivalent to SNMPv2).
MD5
– MD5 authentication with no encryption (packet can't be changed,
however it can easily be analyzed by network sniffers).
SHA
– SHA authentication with no encryption (similar to MD5, only using
different authentication algorithm).
MD5+DES
– authentication is done by MD5, while encryption is done by DES.
SHA+DES
– authentication is done by SHA, while encryption is done by DES.
SNMPv3 Notification (trap)
Authentication and
Encryption Mode
None
– no authentication or encryption (no security - equivalent to SNMPv2).
MD5
– MD5 authentication with no encryption (packet can't be changed,
however it can easily be analyzed by network sniffers).
SHA
– SHA authentication with no encryption (similar to MD5, only using
different authentication algorithm).
MD5+DES
– authentication is done by MD5, while encryption is done by DES.
SHA+DES
– authentication is done by SHA, while encryption is done by DES.
PoE MIB
– Enable
Notifications
Enable/Disable the following PoE trap reports
PoE power was provided / removed from PD device.
Unit total power consumption exceeds xy% out of max unit power.
Unit total power consumption was restored to less than xy% out of max unit
power.
PoE MIB - Notify Exceeded
Power Usage (1-99%)
Report (if enabled) whenever unit total power consumption (xy%) percentage
out of unit max power exceeds this percentage value. Also, report whenever
unit total power drops below the same percentage.
