Power Over Ethernet Power View Pro User Guide
Copyright
2013
Microsemi
10
Rev.1.0, 17-Dec-13
Analog Mixed Signal Group
1 Enterprise, Aliso Viejo, CA 92656, USA; Phone (USA): (800) 713-4113, (ROW): (949) 221-7100 Fax: (949) 756-0308
2.2 System Network Management Capabilities
The unit can be accessed from any computer using any Web browser, SNMPv2c/SNMPv3 management station
or Telnet.
Web Interface
– used to view unit PoE and network status, unit configuration and view unit production
information.
SNMP v2/v3
– Monitor unit over the network (MIB-II RFC1213), monitor / configure unit PoE
capabilities (RFC3621).
Telnet
– used to view unit PoE & network status, unit configuration and production information
.
Software update, enable/disable PoE functionality, ping remote network devices for connectivity tests.
SNMP Traps
– used to report various PoE events such as PoE PD insertion / removal.
SysLog
– used to report PoE events, invalid remote user access, initial DHCPv4/v6 address, etc.
2.3 Ethernet Switch Network Capabilities
10M/100M/1000Mbit Half-Duplex / Full-Duplex Ethernet speed
8K internal MAC address lookup engine
Auto MDIX
Jumbo frames
2.4 POE Capabilities
The following Power over Ethernet (PoE) options are available:
IEEE 802.3at
– Delivers up to 30 watts per port.
PoE Enable/Disable
– Enable/disable PoE ports power output (Ethernet data is always enabled).
Weekly Schedule
– Automatic activation/deactivation of PoE ports based on time of day.
Remote device reset
– Turning temporary device power off and back on resets attached PD device.
2.5 Configuration Options
Web-based
: Via a Web browser
SNMPv1/2c/3
: Via an SNMP management application on a remote computer
Telnet
: Via a Telnet application on a remote computer
NOTE:
The unit default IPv4 address is 192.168.0.50. Make sure that a computer network card is
configured to the same IPv4 network (for example 192.168.0.40).
NOTE:
For security reasons, when the unit is shipped the
SNMP is disabled
. Prior to enabling
SNMP, modify SNMP community strings and only then enable it.
