LVS-95XX Series Barcode Quality Station Operations Manual
LVS-95XX Series Barcode Quality Station Operations Manual - English
Page 93 of 94
Preventive Maintenance Schedule
LVS-9510
To maintain a clean and clear appearance, clean only the outside of the viewing window with a
commercially available household glass cleaner, such as Windex®, Glassex®, VISS®, and Mr.
Muscle®. Do not use an industrial-strength glass cleaner. Do not clean the inside of the viewing
window.
Replace the Calibrated Conformance Standard Test Card every two years.
The LVS-9510 light tray has LED lights which have a life span of approximately 10,000 hours; thus,
there should be no replacement concerns with the light tray. Contact Microscan or your Microscan
distributor with any questions.
LVS-9570
Sensor Cleaning Instructions:
The sensor window may need to be cleaned daily, depending on use. Debris on the sensor window
may cause the LVS-9570 to not grade accurately.
Locate the following supplies:
•
One of the following:
o
Commercially available household glass cleaner, such as Windex®, Glassex®,
VISS®, and Mr. Muscle®
o
Rubbing
alcohol
o
Camera lens cleaning solution
•
Soft, lint-free, non-abrasive towel or cloth, or tissue paper designed to clean a lens
Dampen the cloth with the cleaning solution and wipe the window. Inspect the window closely,
looking for any label debris that may get stuck on the window. Do not scrape the window with a sharp
object as this may damage the window causing the system to not grade correctly.
Any damage to the sensor window will be detected during the calibration process.
•
DO NOT directly spray the sensor glass with glass cleaner; always spray a towel or cloth with
glass cleaner and then gently wipe the sensor glass.
•
DO NOT use an industrial-strength glass cleaner.
Rubber Roller Instructions:
The LVS-9570 rubber roller may need cleaning periodically, as it is important to keep the roller free of
debris, adhesive buildup and other surface materials.
Locate the following supplies:
•
Dishwashing
liquid
•
1 cup of water
•
Lint-free
cloth
Warning:
Use only dishwashing liquid to clean the rubber roller. Do not clean the
roller with alcohol, window cleaner or petroleum-based products, as this causes
the rubber to crack.
Mix a few drops of dishwashing liquid into a cup of water and place a lint-free cloth into the solution
until the cloth is saturated. Ring out the cloth so that no water drips from the cloth. Wipe down the
rubber roller surface, removing any debris. As you wipe, turn the roller to clean the entire surface.
Then, rinse out the cloth and wipe down the rubber surface again to remove any dishwashing liquid
from the roller. Allow the roller to dry before using.
