Error Codes
Updating Firmware on
1600T Cameras
E
Rev. 1G, Dec 2008
HawkEye™ 1600T Smart Camera Guide
E-9
Error Codes
When the Smart Camera fails to boot (i.e., self tests fail), the LEDs on the front
of the unit flash the error code in binary form. Table E–1 describes the
Mode/Status LED power-on sequence and error codes.
TABLE E–1.
Mode/Status LED Power-On Sequence & Error Codes
Mode
Fail
Pass
Trig
Test Performed
•
Data Line Test
•
Address Line Test
•
•
Bootloader CRC Check
•
Kernel CRC Check
•
•
RS-232 Internal Loopback
•
•
FPGA Load Test
•
•
•
FPGA PCI Config Test
•
FPGA Video Buffer Test
•
•
FPGA DMA Transfer Test
•
•
FPGA Expose Done Interrupt Test
•
•
•
FPGA Read Done Interrupt Test
Summary of Contents for HawkEye 1600T
