Microscan HawkEye 1600T, Manual

Page: 76 / 79

Appendix E Updating Firmware on 1600T Cameras
E-8 HawkEye™ 1600T Smart Camera Guide Rev. 1G, Dec 2008
Use DHCP: 0 - 1
Save parameters to flash? [y/n] - y
Saving boot parameters to flash……done.
•
Network Name
— This is limited to 19 characters. Any input string longer
than 19 characters is truncated automatically to the first 19 characters. The
string is erased by entering the '.' (period) character.
• Static IP, Subnet Mask, Gateway — These must contain an address in
valid IP format. If you enter an invalid address, you are prompted to re-enter
the value until a valid address is entered or the Enter key is pressed
(effectively skipping the update for this field).
•
DHCP
— The value for DHCP value is either a 0 (zero) or 1 (one).
• MAC Address — You cannot change the MAC Address, since this is set in
the factory.
Reset User Account
Each HawkEye™ Smart Camera is protected by a User/Password combination
where the password is encrypted using the unit’s MAC address. The Reset User
Account utility allows you to reset the User/Password combination to the default
values of:
User: hawkeye
Password: vision
Resetting the account is password protected with the string acuity.
>> 2
Enter password to reset User Account to defaults: ******
Exit to Application
The Exit to Application selection exits the Main Menu and switches execution to
the beginning of application code stored in Non-Volatile memory. If there is no
valid application program in Non-Volatile memory, the Main Menu is
re-displayed.