14 Installation
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s
Manual
MICROPLEX iF60C
Edition 1.0
2.2. Printer Installation (Environment and Power Standards)
- The chosen location should be dust-free and well ventilated.
- Damaging environmental factors such as metal vapors, organic gas
(for example ammonia), oil mist, corroding lixivium or the like must
not come in contact with the printer.
- Position the printer on solid and level ground.
- Do not expose the printer to shocks or vibrations.
- The printer should not be located near volatile or combustible
materials (e.g. a curtain).
- Before operating the device the printer has to be levelled exactly.
!
The printer’s first installation has to be done by a trained service
engineer.
!
- The printer must always remain levelled — every moving of the printer
causes the necessity of new levelling .
- Avoid locating the printer close to an air current ( e.g. ventilators)
and care for no exhaust gas from the machine is directly applied to
humans.
- The printer should not be exposed to direct sunlight.
- Do not expose the printer to abrupt temperature changes.
- In order to run the printer reliably, please maintain the following
environmental conditions:
Temperature:
+15°C to +25°C (59°F to 77°F)
with temperature variation not exceeding
10°C per hour.
Relative humidity: 35% to 70% operating
with humidity variation not exceeding
20% per hour.
After moving the printer allow all components of the device and the
consumables to reach the new environmental conditions.
